On you can see how the pilot connects to the Volvo network via an ECI-100, or in the you can see how to connect via the Volvo pilot gateway (the connections are different depending on which gateway you use.) Volvo functions including Dynamic Positioning, Water Sport Control, alarms, control and the onboard Maintenance Assistant will work through a Volvo 7" display.The pilot controls on the joystick and Volvo display will not operate as these are dedicated to the Volvo pilot.In a system with a Volvo joystick, Joystick Driving will not function, as this is a Volvo pilot function.transmission) alarms which are not translated across to the Raymarine system You should still have a 4" or 7" Volvo display at the helm for proprietary (e.g.There are also a few things to be aware of in a system such as this: ![]() The ECI-100 does not pass any data (except pilot steering commands) back to the EVC system, so you may need a GPS on the Volvo side for fuel calculations on their engine displays or, again, use Volvo gateways.If you go the Volvo gateways, you need both for full functionality.You should not mix Volvo and Raymarine gateways in the same system: choose either/or.Volvo do not test and approve the ECI-100, so you may prefer to use the Volvo equivalents.You need a 'gateway' to translate between the Raymarine system and the Volvo system: this can be Raymarine's ECI-100 or dual Volvo gateways, one for pilot control and one for engine data (the ECI-100 performs both functions.) The Raymarine system will function the same whether you use 1x ECI-100 or 2x Volvo gateways, but: ![]() Single-sterndrive systems are supported, with Volvo EVC revisions C and later including current EVC-2. Volvo are understandably keen on discouraging people from using any electronics other than their own, but our EV2 drive-by-wire autopilot can steer a wide range of IPS and Aquamatic drive-by-wire sterndrive systems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |